Shure LX88-II User Manual

Page 6

4. If the antennas are to be remote mounted, insert the supplied plastic plugs

into the holes on the front of the brackets (Figure 7).

INSTALLING THE HOLE PLUGS

FIGURE 7

БББ

ББББ

ББ

ББББ

NOTE: If you install the receiver in a rack mount, we recommend you front
mount or remote mount your antennas.

CONNECTING THE POWER SUPPLY

1. Connect the ac adapter to the POWER jack on the rear panel of the receiver.

2. Plug the ac adapter into an appropriate power outlet.

CONNECTING THE ANTENNAS

There are several ways the antennas can be connected to the receiver.

•

When used as a stand-alone unit, attach the supplied quarter-wave antennas to

the antenna connectors on the receiver back panel. For best performance, the
receiver antennas should point straight up (Figure 8).

INSTALLING THE ANTENNAS

FIGURE 8

•

If you wish to front mount the antennas, ask your Shure dealer for information

on the WA503 Front Mount Conversion Kit.

•

If you wish to remote mount the antennas, ask your Shure dealer for informa-

tion on the WA380

-Wave

telescoping antennas or WA490

-Wave cable

antennas and a WA421 cable extension kit.

CONNECTING THE RECEIVER

There are two ways to connect the receiver to a mixer or a karaoke unit:

Two Independent Channels (Figure 9)

LX88-

AUDIO MIXER

or KARAOKE

UNIT

CONNECTING SEPARATE CHANNELS

FIGURE 9

BACK

AC ADAPTER (PS20E)

Connect the receiver outputs for channels 1 and 2 to the mixer or karaoke unit

inputs using balanced, 2–conductor, shielded cables with 3-pin XLR connec-
tors, or unbalanced, single–conductor, shielded cables with

-inch phone

plugs.

Two Channels Mixed Into One (Figure 10)

LX88-

AUDIO MIXER

or KARAOKE

UNIT

CONNECTING MIXED CHANNELS

FIGURE 10

BACK

AC ADAPTER (PS20E)

Connect the Mixed Channels output to the mixer or karaoke unit input using

an unbalanced, single-conductor, shielded cable with a

-inch phone plug.