Applications settings – Samsung A847M User Manual
Page 119
Changing Your Settings 112
• Auth Type: select the type of authentication used for this WAP connection: None, Normal, or Secure.
• User ID: enter the User
ID required to connect to the network.
• Password: enter the user password required to connect to the network.
• Protocol: set the connection protocol used by the WAP browser: HTTP, WAP, or Other.
• Home URL: enter the URL address of the page to use as your homepage.
• Proxy Address (Protocol:HTTP): MEdia Net set as the proxy server address and port.
• Gateway Address (Protocol WAP): set the Gateway Address.
• Secure Connection (Protocol WAP): set the secure connection on or off.
• Linger Time (sec.): set a time period (in seconds) after which the network is disconnected if there is no new data traffic.
• Advanced Settings: allows you to configure some of the P-specific information: Static
IP, Static DNS, Server information,
and Traffic Class. Highlight this option and press the Edit soft key to access the following options:
–
Static IP: specify if you want to manually enter an IP address. Remove the check mark if you want the server to automatically
assign the IP address.
–
Local Phone IP: allows you to configure the local phone IP address.
–
Static DNS: specify if you want to manually enter the Domain Name Server (DNS) address. Remove the check mark if you
want the server to automatically assign the address.
–
Server 1/Server 2: enter the Domain Name Server (DNS) addresses.
–
Traffic Class: select the traffic class, press the Edit soft key, select a Traffic Class (Subscribed, Conversation, Streaming,
Interactive, or Background) and press the OK soft key.
Note: The WAP settings may vary depending on the service provider.
Applications Settings
The Applications Settings feature allows you to configure the functional parameters for most of the onboard
applications. These applications are described in more detail within other sections of this manual.
1.
In Idle mode, press
➔
Settings
➔
Applications Settings and press the Select soft key or the
key.