Connecting an external monitor, Connecting to other compatible computers, Connecting to the computer audio input – Sharp PGD210U User Manual
Page 18
E-17
5. Connecting an external monitor
Connect your computer monitor to the projector’s COM-
PUTER RGB OUTPUT terminal to view images simulta-
neously on the external monitor and the projection
screen. Select either RGB 1 or RGB 2 to output the
images to the monitor.
5
3. Connecting to other compatible
computers
When connecting the projector to a compatible computer
other than an IBM-PC (VGA/SVGA/XGA/SXGA) or
Macintosh series, a separate cable may be needed.
Please contact your dealer for ordering information.
Notes:
• Connecting computers other than the recommended types may
result in damage to the projector, the computer, or both.
• Connect the audio from the computer to the COMPUTER AUDIO
INPUT terminal.
4. Connecting to the COMPUTER AUDIO
INPUT
• The COMPUTER AUDIO INPUT 1 accepts audio from
the COMPUTER RGB 1 input, and the COMPUTER
AUDIO INPUT 2 accepts audio from the COMPUTER
RGB 2 input.
• Connect a 3.5 mm Stereo Minijack cable from the
audio output terminal on the computer to the
COMPUTER AUDIO INPUT terminal on the projector.
4
Caution (Apple Macintosh):
Do not connect the COMPUTER RGB OUTPUT to any moni-
tor except the following:
Apple Color RGB Monitor 13
؆/14؆ (640 ן 480), 16؆/17؆ (832
ן 624) or 19؆ (1,024 ן 768)
The output signal from the projector to the monitor should be
the same as the input signal from the computer to the
projector.
Examples:
Input 13
؆/14؆ (640 ן 480)
→
Output (640
ן 480)
Input 16
؆/17؆ (832 ן 624)
→
Output (832
ן 624)
Input 19
؆ (1,024 ן 768)
→
Output (1,024
ן 768)
Note:
• The supplied adaptor is only for use with H-SYNC and V-SYNC
output. No picture will appear when connected to monitors that
only use C-SYNC.
COMPUTER RGB
IN 1
OUT
IN 2
Optional Macintosh
adaptor cable
External Macintosh
monitor
or
U.S.A. ONLY
External IBM-PC
monitor
Direct
connection
Notes:
• When using the projector with an external IBM-PC monitor, connect
the monitor using the supplied cable. When using the projector with a
Macintosh monitor, an optional adaptor cable is required. Before
using any other type of monitor, carefully check the monitor’s inter-
face specifications and make sure that they match the specifications
of the projector’s interface.
• The external monitor output will only display an analog computer
input signal. It will not display a digital or video input signal. To split
the composite video signal, use a video distribution amplifier. This is
available from your local dealer. The computer RGB output will only
loop through the same signal connected to the computer RGB input.
(VGA IN
→
VGA OUT, Mac IN
→
Mac OUT)
COMPUTER AUDIO
PC CONTROL
1
2
AUDIO
OUTPUT
IN 2
WIRED
REMOTE
IN 1
IN 2