Sharp PGD210U - Manual (Page 13)

E-12
Example of a ceiling-mount setup
Before mounting the projector, be sure to contact your nearest Authorized Sharp Industrial LCD Products Dealer to
obtain the manufacturer recommended ceiling mount bracket (sold separately). (AN-XGCM40 Ceiling Mount
Bracket, AN-EP101AP Extension Tube for AN-XGCM40).
TOP VIEW
• If the relative positions of the projector and the screen are not properly adjusted, the picture will be distorted.
Example of a standard setup
TOP VIEW
If the projector and screen are not
centered properly, the picture will be
distorted, making viewing difficult.
▼
▼
90˚ 90˚
Lens center
Lens center
90˚
SIDE VIEW
The projector lens should be centered
in the middle of the screen. If the projector and screen are not
centered properly, the picture will be
distorted, making viewing difficult.
Lens center
Using the horizontal reverse function makes the following setups possible.
Example of a reversed image setup
• By placing a mirror (normal flat type) in front of the lens and using the horizontal reverse function, the image reflected from
the mirror can be projected onto the screen.
• Rear projection with a rear projection screen is also possible when using the horizontal reverse function.
AUDIENCE SIDE
Mirror
90˚
The projector lens should be centered
in the middle of the screen.
Rear Projection
90˚
SIDE VIEW
Lens center
90˚
Note:
• A polarizing screen cannot be used with this projector.