Southbend SB1020 - Manual (Page 44)

-42-
For Machines Mfg. Since 8/09 Model SB1020 S E R V I C E
V1
U1
W1
1
7 9
3
6 5 4
2
8
Figure 52. Saw motor rewired for 220V.
9. Re-install the pump motor junction box
cover, then remove the saw motor junction
box cover.
10. Remove wires 4, 5, and 6 from the terminal
block posts and remove the three pre-
installed jumpers. The jumpers will not be
needed for 220V configuration (see Page 44).
11. Remove wires 7, 8, and 9 from the lower
terminal block posts.
12. Remove the two screws securing the
terminal block to the motor housing.
13. Pair wires 4 and 7, 5 and 8, and 6 and 9. Re-
attach these wire pairs to the terminal block
as shown in Figure 52.
14. Reposition the terminal block into its
original position and secure it in place with
the screws removed in Step 12.
15. Replace the saw motor junction cover and
tighten the screws.
16. Remove the NEMA 5-15 plug from the power
cord and attach a NEMA 6-15 plug per the
manufacturer’s instructions.