Southbend SB1020 - Manual (Page 33)

MAiNTENANCE
For Machines Mfg. Since 8/09 Model SB1020
-31-
M A I N T E N A N C E
Maintenance Schedule
For optimum performance from your machine,
follow this maintenance schedule and refer to
any specific instructions given in this section.
Daily
• Check/correct loose mounting bolts.
• Check/correct damaged or dull saw blade.
• Check/correct worn or damaged wires.
• Clean/protect table.
• Clean metal chips from upper and lower
wheel areas, and empty the chip chute.
• Correct any other unsafe condition.
Monthly
• Lubricate all components outlined in this
section, with the exception of the gearbox.
• Monitor gearbox oil level by removing the fill
plug and checking that the oil level is even
with the fill hole (with headstock lowered)
Yearly
• Lubricate gearbox.
Always disconnect
machine from power before
performing maintenance or
serious personal injury may
result.
!
Cleaning
Use a brush and a shop vacuum to remove chips
and other debris from the machine. Keep the
non-painted surfaces rust-free with regular
applications of a high quality rust preventative.
Periodically remove the blade and thoroughly
clean all metal chips or built-up grease from the
wheel surfaces and blade housing.
Lubrication
Before applying lubricant to any area, wipe the
area clean to avoid contamination.
Lubricate the following areas:
A. Blade Tension Mechanism: Open the main
blade guard, then drop a few drops of oil on
the tension knob lead screw.
B. Blade and guides: Drop a few drops of light
machine oil on the blade and the blade
guides daily.
C. gear Box: Change the gear oil annually.
D. Table and Machined Surfaces: Keep bare
metal surfaces rust-free with regular
applications of a quality way oil.
E. Vise Leadscrew: Clean the leadscrew, then
brush on a thin layer oft grease as needed.
Figure 36. Lubrication points.
A
B
C
D
E