Sanyo PLC - 12BL - Manual (Page 18)

18
USB 1 AUDIO 1
R
ANALOG
ANALOG RGB
COMPUTER OUT
COMPUTER IN-2
COMPUTER IN-1
R G B H V
L (MONO)
(MONO)
CONTROL PORT 1
USB 2
R/C JACK SERIAL PORT
AUDIO 2
AUDIO OUT
R L
R L
CONTROL PORT 2
DIGITAL
Before using with digital connection, install (Plug in) Graphic
Accelerator PC card into card bus slot of the computer and set up
the computer following instructions in the Graphic Accelerator PC
card package.
SERIAL
PORT
OUTPUT
COMPUTER
SERIAL PORT
INPUT PS/2 PORT
INPUT
AUDIO CABLE
(NOT PROVIDED)
AUDIO CABLE
(NOT PROVIDED)
MOUSE CABLE FOR
PS/2 PORT
(PROVIDED)
MOUSE CABLE FOR
SERIAL PORT
(PROVIDED)
R L
R L
Speaker (L) Speaker (R)
Amp.
L
R
R
L
AUDIO
INPUT
SPEAKER
OUT
COMPUTER
AUDIO OUTPUT
COMPUTER
AUDIO INPUT 1
CONTROL PORT
OUTPUT 1
COMPUTER
AUDIO OUTPUT
SERIAL PORT CABLE
(NOT PROVIDED)
COMPUTER
INPUT 1
(DIGITAL)
DIGITAL FLAT
PANEL CABLE
(PROVIDED)
CONNECTING AN IBM-COMPATIBLE LAPTOP COMPUTER
(DIGITAL INPUT CONNECTION)
GRAPHIC
ACCELERATOR
PC CARD
DIGITAL
OUTPUT
ANALOG
OUTPUT
INSTALL (PLUG)
INTO PC CARD
BUS SLOT
NOTE: When connecting the cable, the power cords of both the projector and the external equipment should be
disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on.
NOTE: This connection need optionally sold Graphic Accelerator PC card.
For this information, contact to your authorized dealer.
CONNECTING THE PROJECTOR