Sanyo PLC - 12BL - Manual (Page 16)

16
CONNECTING AN IBM-COMPATIBLE DESKTOP COMPUTER
(DIGITAL INPUT CONNECTION)
CONNECTING THE PROJECTOR
USB 1 AUDIO 1
R
ANALOG
ANALOG RGB
COMPUTER OUT
COMPUTER IN-2
COMPUTER IN-1
R G B H V
L (MONO)
(MONO)
CONTROL PORT 1
USB 2
R/C JACK SERIAL PORT
AUDIO 2
AUDIO OUT
R L
R L
CONTROL PORT 2
DIGITAL
COMPUTER
MONITOR CABLE
(NOT PROVIDED)
SERIAL PORT
INPUT
AUDIO CABLE
(NOT PROVIDED)
AUDIO CABLE
(NOT PROVIDED)
COMPUTER
AUDIO INPUT 1
CONTROL PORT
OUTPUT 1
MOUSE CABLE FOR
PS/2 PORT
(PROVIDED)
MOUSE CABLE FOR
SERIAL PORT
(PROVIDED)
PS/2 PORT
INPUT
L R
R L
Speaker (L) Speaker (R)
Amp.
L
R
R
L
AUDIO
INPUT
SPEAKER
OUT
COMPUTER
AUDIO OUTPUT
SERIAL PORT CABLE
(NOT PROVIDED)
SERIAL
PORT
OUTPUT
COMPUTER
AUDIO OUTPUT
COMPUTER
INPUT 1
(DIGITAL)
DIGITAL FLAT
PANEL CABLE
(NOT PROVIDED)
GRAPHIC
ACCELERATOR
BOARD
DIGITAL
OUTPUT
ANALOG
OUTPUT
INSTALL (PLUG)
INTO PCI BUS SLOT
NOTE: When connecting the cable, the power cords of both the projector and the external equipment should be
disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on.
Before using with digital connection, install (Plug in) Graphic Accelerator
Board into PCI bus slot of the computer and set up the computer
following instructions in the Graphic Accelerator Board package.
NOTE: This connection need optionally sold Graphic Accelerator Board.
For this information, contact to your authorized dealer.