Sanyo PLC - 12BL - Manual (Page 11)

11
CONNECTING THE PROJECTOR
SIDE OF THE PROJECTOR (CONNECT THE COMPUTER)
COMPUTER INPUT-1 TERMINAL (ANALOG HDB 15-PIN)
Used to connect a computer to the projector.
COMPUTER INPUT-1 TERMINAL (DIGITAL MDR 20-PIN)
Used to connect a computer to the projector.
COMPUTER INPUT-2 JACKS (BNC TYPE x 5)
Used to connect a computer to the projector.
MONITOR OUTPUT TERMINAL (ANALOG HDB 15-PIN)
Used to connect a monitor to the projector.
COMPUTER AUDIO INPUT-1 JACKS (R and L)
Used to connect an audio output from the computer to the
projector.
COMPUTER AUDIO INPUT-2 JACKS (R and L)
Used to connect an audio output from the computer to the
projector.
AUDIO MONITOR OUTPUT JACKS (R and L)
Used to connect an audio input from audio equipment to the
projector.
CONTROL PORT-1 CONNECTOR
Used to connect a mouse cable to the projector.
CONTROL PORT-2 CONNECTOR
Used to connect a mouse cable to the projector.
USB PORT-1 CONNECTOR
Used to connect a computer to the projector.
USB PORT-2 CONNECTOR
Used to connect a computer to the projector.
SERIAL PORT TERMINAL (DB9)
Used to connect a computer to the projector.
WIRED REMOTE JACK
When using the wired remote control, connect the
remote cable to this jack.
USB 1 AUDIO 1
R
ANALOG
ANALOG RGB
COMPUTER OUT
COMPUTER IN-2
COMPUTER IN-1
R G B H V
L (MONO)
(MONO)
CONTROL PORT 1
USB 2
R/C JACK SERIAL PORT
AUDIO 2
AUDIO OUT
R L
R L
CONTROL PORT 2
DIGITAL
10
1
13
11
2
3
4
7
6 5 9 8
12
1
2
3
4
5
6
8
9
10
11
12
13
7
TERMINAL OF THE PROJECTOR