Sony SDM-V72W - Manual (Page 11)

- 10 -
Connecting your display to your computer
Turn off the display and computer before connecting. Do not touch the pins of the video signal cable connector as this might bend the pins.
1 Remove the back panel by holding top
with one hand as in the illustration then
snap out the buttons located at each
corner.
2 Remove the cable cover by lightly pulling
top concave portion.
■ Connecting to an IBM PC/AT or compatible
computer
Using the HD15/D-sub cable (supplied),
connect the computer to the display’s HD15
input connector.
Be sure to check the alignment of the HD15/
D-sub cable. Do not force the connector in
the wrong way or the pins might bend.
■ Connecting a Macintosh
When connecting a Macintosh computer,
use an adapter (not supplied) if necessary.
Connect the adapter to the computer before
connecting the video signal cable.
Setup 2
1
2
Connecting a Macintosh Connecting to an IBM PC/AT