SMC Networks SMC7904BRA - Manual (Page 115)

T
ROUBLESHOOTING
A-2
LED Indicators
LAN LED is
Off
• Verify that the Barricade ADSL Router and attached
device are powered on.
• Be sure the cable is plugged into both the Barricade
ADSL Router and the corresponding device.
• Verify that the proper cable type is used and that its
length does not exceed the specified limits.
• Be sure that the network interface on the attached
device is configured for the proper communication
speed and duplex mode.
• Check the adapter on the attached device and cable
connections for possible defects. Replace any
defective adapter or cable if necessary.
Network Connection Problems
Cannot ping the
Barricade ADSL
Router from the
attached LAN
• Verify that the IP addresses are properly configured.
For most applications, you should use the Barricade
ADSL Router’s DHCP function to dynamically assign
IP addresses to hosts on the attached LAN. However,
if you manually configure IP addresses on the LAN,
verify that the same network address (network
component of the IP address) and subnet mask are
used for both the Barricade ADSL Router and any
attached LAN devices.
• Be sure the device you want to ping (or from which
you are pinging) has been configured for TCP/IP.
Troubleshooting Chart
Symptom Action