Sterling Plumbing Bypass Shower Doors 5400 Series - Manual (Page 22)

Instale los paneles de la puerta (cont.)
Ajuste las ruedas aflojando el tornillo de la rueda y moviendo la rueda en la
ranura.
Si la parte inferior
del panel de la puerta del lado que se está ajustando está más
lejos de la pared que la parte superior del panel, suba la rueda.
Si la parte superior
del panel está más lejos de la pared que la parte inferior del
panel, baje la rueda.
Vuelva a instalar el panel de la puerta.
Repita el procedimiento según sea necesario.
10. Install the Center Guide
Make a small mark on the threshold at the center of the bottom track on the
inside of the shower using a pencil.
Position the center guide on the bottom track with the front lip of the center guide
in the groove of the bottom track.
Position both door panels so they are aligned in the slots in the center guide.
Holding the center guide tightly against the bottom track, make sure the door
panels can roll from wall-to-wall without binding.
If the doors bind, refer to the panel installation sections and make the needed
adjustments.
IMPORTANT! Risk of product damage. Do not overtighten the screws. The center
guide may crack.
While holding the center guide tightly against the bottom track, drive in the
provided self-tapping screw with a screwdriver. Repeat with the second screw.
Panels
Panneaux
Paneles
Panels
Panneaux
Paneles
Center Guide
Guide central
Guía central
Threshold
Seuil
Umbral
Bottom Track
Rail inférieur
Carril inferior
Self-Tapping Screws
Vis tarauds
Tornillos autorroscantes
Bottom Track
Rail inférieur
Carril inferior
Center Guide
Guide central
Guía central
1063216-2-L 22 Sterling