Sony SA-KL50W - Manual (Page 8)

Operations
8 GB
Operations
Listening to the Sound
1 Turn on the connected KL-50W series TV or amplifier and
select the programme source.
2 Press the POWER switch.
The speaker system turns on and the POWER indicator lights up in
red.
3 Play the programme source.
When the speaker system receives a signal, the POWER indicator
turns green.
Adjust the volume of the KL-50W series TV or amplifier so sound
from the front speakers is not distorted.
The standby mode
When no signal is received, the speaker system goes into standby mode and
the POWER indicator turns red after a few minutes. When a new signal comes
into the speaker system, the speaker system returns to active mode and the
POWER indicator turns green.
To turn off the power
Press the POWER switch to release the switch.
If you hear noise when you turn off the speaker system , turn down the
speaker system volume, or turn off the KL-50W series TV or amplifier before
turning off the speaker system.
Note
The following actions may cause
damage to the speakers: Setting
the amplifier’s tone control to a
high level, setting an equalizer’s
output to a high level, or inputting
sine waves of 20 Hz to 50 Hz
recorded on a commercially
available test disk or special
sounds (the bass sound of
electronic musical instruments,
popping noise of an analog disc
turntable, sounds with abnormally
enhanced bass, etc.)
When a special disc containing
abnormally enhanced bass is
played, noise may be output in
addition to the original sound. In
such a case, decrease the sound
level.
POWER
Front side