Samsung HCN479W - Manual (Page 14)

14
Y O U R N E W T V
Rear Panel Jacks
Use the rear panel jacks to connect an A/V component that will be connected continu-
ously, such as a VCR or a DVD player.
Because there are two sets of input jacks, you can connect two different A/V components
(i.e., a VCR and a DVD, 2 VCRs, etc.)
For more information on connecting equipment, see pages 17 – 25.
ΠANTENNA terminals
Two independent cables or antennas can be
connected to these terminals. Use ANT-A and
ANT-B terminals to receive a signal from
VHF/UHF antennas or your cable system. Use
the ANT-A OUT terminal to send the signal being
received by the ANT-A terminal out to another
component (such as a Cable Set Top Box). The
PIP channel can be received only when a signal
source is connected to ANT-A.
´ DIGITAL INPUT (Digital
Visual Interface) jack
Receives the digital signals from a Set-top Box.
ˇ COAXIAL OUTPUT
Connect to the a Digital Audio component.
¨ OPTICAL OUTPUT
Connect to the a Digital Audio component.
ˆ SERVICE PORT
For service only.
Ø AUDIO-VIDEO MONITOR
OUTPUT jacks
Connect to the audio/video input jacks of a
recording VCR.
∏ VIDEO INPUT jacks
Connect to the video output jacks of VCRs, DVD
players and similar devices (Two sets are avail-
able: Video1 and Video2).
” AUDIO INPUT jacks
Connect to the audio output jacks of VCRs, DVD
players and similar devices.
’ DVI AUDIO INPUT jacks
Receives the digital audio signals from a set top
box.
˝ S-VIDEO INPUT jack
Connect to an S-VHS VCR or DVD player.
Ô COMPONENT 1, 2 (480i,
480p, 720p, 1080i)
AUDIO/VIDEO INPUT jacks
Connect a source that outputs 480i/480p/720p/
1080i Y,P
B
and P
R
signals, such as a DVD or DTV
Set-Top Box.
00137A-CHAPTER 1 2004/10/18 05:23 PM Page 14