Sharp MD-MT16H - Manual (Page 33)

Note:
● If the total number of tracks on the mas-
ter MiniDisc does not match the total
number of tracks on the newly recorded
MiniDisc, the unit will display “Can’t
WRITE” and the power will be turned off.
If this happens, adjust the total number
of tracks on the newly recorded MiniDisc
using the edit operation, and then try
again from step 2.
32
2
When the recording is complete, remove
the newly recorded MiniDisc and load
the master MiniDisc into the MD-MT16E.
● Do not mistake the master MiniDisc
for the newly recorded MiniDisc.
3
Whilst in the stop mode, press the EDIT
button to select “NAME STAMP”.
4
Press the ENTER/SYNC button.
● To cancel the operation, press the
■ /:OFF button.
5
Press the ENTER/SYNC button.
● The character information of the
master MiniDisc is being read.
6
When the unit displays “CHANGE MD”,
remove the master MiniDisc.
● Remove the master MiniDisc without
turning off the power. If you do, the
operation will be cancelled.
7
Load the newly recorded MiniDisc into
the MD-MT16E.
● To cancel the operation, press the
■ /:OFF button.
8
Press the ENTER/SYNC button.
● The unit will finish recording the char-
acter information and enter the stop
mode.
4 3
6 5
* MD-MT16H FOR UK(22-42) 99.4.2, 0:55 PM 33