Sharp MD-MT16H - Manual (Page 13)

12
To turn off the power:
Press the ■ /:OFF button whilst in the stop
mode.
● After the track number has been
written on the disc, the power will
shut off automatically.
(For details about the TOC, see page
21.)
To remove the MiniDisc:
Turn off the power and move the OPEN le-
ver in the direction indicated by the arrow.
Recordings can not be made in the
following situations:
● Recording on a playback-only
MiniDisc (commercially available
music).
● If a MiniDisc is protected against
accidental erasure. (page 10)
About the recording level:
● If the recording level is too low, the
playback sound volume may be too
low to hear well. If it is too high,
the playback sound may be greatly
distorted. Since digitally recorded
CDs have a large dynamic range
(the volume can vary tremendously
from very soft to extremely loud),
do not set the recording level any
higher than is necessary.
Precautions when recording:
● Do not jar or bump the main unit whilst
recording. Otherwise, the recording
may be unusable.
● Depending on the strength and type
of playback signal in the original
recording, the new recording may
not begin or pause at the correct point
when in the synchro mode.
If this happens, try making a manual
recording.
Precautions when inserting a
MiniDisc:
● To insert a MiniDisc, push on the
middle of the edge of the disc whilst
holding it parallel to the main unit.
● If any resistance is felt, do not try
to force the MiniDisc into the unit,
as it may cause damage to the unit.
If resistance is felt, remove the
MiniDisc and try reloading it.
■ Recording from a tuner or a CD
(Manual recording)
Manual recordings can be started and
stopped as you like.
1
Place the unit in the recording stand-by
mode.
(Perform steps 1 - 4 in the “Synchro
recording” section.)
2
Press the
06
button.
● Recording will start.
● To record from a CD, press the
06
button, and then start playback on the
equipment connected to this unit.
● Track numbers can be created whilst
recording. (Page 18)
To interrupt recording:
Press the
06
button whilst recording.
● The unit will enter the recording stand-by
mode.
● To resume recording, press the
06
button again.
The track number will be increased by
one each time you interrupt a recording.
2
1
OPEN
* MD-MT16H FOR UK(01-21) 99.4.2, 0:57 PM 13