Sharp MD-MT16H User Manual
Page 12
■
Recording from CDs or MDs
(Synchro recording)
11
RECORDING USING THE ANALOGUE CABLE
Synchro recording is a method that detects the
playback sound from the source equipment.
When sound is present, it automatically starts
the recording. When the source is silent, the
recording will be paused.
●
Adjust the recording level so that the
maximum sound volume from the
source makes the reading swing
somewhere between – 4 dB and 0 dB.
●
To record from a CD, first adjust the
recording level.
Then put the equipment connected to
this unit into the playback stand-by
mode.
5
Press the ENTER/SYNC button.
1
Connect the external equipment.
(See page 9.)
2
Insert a recordable MiniDisc.
3
Press the REC button.
●
To record from a tuner, first tune in a
broadcast.
●
To record from a CD, first start playing
the track you want to record.
6
Begin playback on the source equipment.
●
Recording will begin automatically.
To interrupt recording:
●
When the source equipment is stopped,
the unit will enter the synchro recording
stand-by mode.
When playback is resumed, a recording
will be resumed.
●
If a silence lasts for 3 seconds or more,
the recording will be paused.
●
Pressing the
06
button on this unit
(when in this mode) will cause the unit
to enter the recording stand-by mode
and cancel the synchro recording mode.
●
The track number will be increased by
one each time the recording is interrupted.
To stop recording:
Press the
■
/:OFF button.
●
If the unit is left unattended after the
recording is complete, the power will
automatically shut off in approximately
2 minutes.
0dB
–4dB
Flashing
4
Whilst playing sound from the external
equipment connected to this unit, press
the
5
or
4
button to adjust the
recording level.
2
1
3
4
OPEN
* MD-MT16H FOR UK(01-21)
99.4.2, 0:57 PM
12