Sharp SD-EX200 - Manual (Page 7)

7
SD-EX200
03/3/14 SD-EX200_sec.fm TINSZ0523AWZZ
2
3
4
5
6
7
8
1
Gen
e
ral
In
fo
rmatio
n
- Pr
e
cau
ti
o
n
s
-
Precautions
„ General
Warning:
z The voltage used must be the same as that specified on this unit. Using this prod-
uct with a higher voltage other than that which is specified is dangerous and may
result in a fire or other type of accident causing damage. SHARP will not be held
responsible for any damage resulting from use of this unit with a voltage other than
that which is specified.
z CD players use a laser pickup which can damage the eyes if viewed directly.
Do not look at the pickup, and do not touch the pickup directly.
„ Volume control
The sound level at a given volume setting depends on speaker efficiency, location
and various other factors. It is advisable to avoid exposure to high volume levels,
which occurs while turning the unit on with the volume control setting up high, or
while continually listening at high volumes.
z Please ensure that the equipment is positioned in a well-ventilated area and en-
sure that there is at least 4" (10 cm) of free space along the top and sides of the
equipment.
z Use the unit on a firm, level surface free from vibra-
tion.
z Keep the unit away from direct sunlight, strong mag-
netic fields, excessive dust, humidity and electronic/
electrical equipment (home computers, facsimiles,
etc.) which generates electrical noise.
z Do not place anything on top of the unit.
z Do not expose the unit to moisture, to temperatures higher than 140°F (60°C) or to
extremely low temperatures.
z If your system does not work properly, disconnect the AC power cord from the AC
outlet. Plug the AC power cord back in, and then turn on your system.
z In case of an electrical storm, unplug the unit for safe-
ty.
4" (10 cm) 4" (10 cm)
4" (10 cm)
z Hold the AC power plug by the head when removing it
from the AC outlet, as pulling the cord can damage in-
ternal wires.
z Do not remove the outer cover, as this may result
in electric shock. Refer internal service to your lo-
cal SHARP service facility.
z This unit should only be used within the range of 41°F - 95°F (5°C - 35°C).