Sharp SD-EX200 - Manual (Page 11)

11
SD-EX200
03/3/14 SD-EX200_sec.fm TINSZ0523AWZZ
2
3
4
5
6
7
8
1
Prepara
tion f
o
r U
s
e
- Re
mot
e
c
ontr
o
l -
Remote control
„ Battery installation
1
Remove the battery cover.
2
Insert the supplied batteries according to the direction indicated in
the battery compartment.
3
Replace the cover.
Precautions for battery use:
z Replace all old batteries with new ones at the same time.
z Do not mix old and new batteries.
z Remove the batteries if the unit will not be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
z Do not use rechargeable batteries (nickel-cadmium battery, etc.).
z Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
z Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or simi-
lar).
z Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
z Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
z Keep the remote control away from moisture, heat, shock, and vibrations.
„ Test of the remote control
Check the remote control after verifying all the connections (see pages 12 - 13).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy the
music. When inserting or removing the batteries, push them toward the battery termi-
nals.
Remote sensor
15˚ 15˚
8" - 20'
(0.2 m - 6 m)