Sharp SD-EX200 - Manual (Page 14)

14
SD-EX200
03/3/14 SD-EX200_sec.fm TINSZ0523AWZZ
Prepara
tion f
o
r U
s
e
- Ge
ne
ra
l c
o
ntr
o
l -
General control
„ To turn the power on
Press the ON/STAND-BY button to turn the power on.
If the power does not turn on, check the AC power cord is plugged in properly.
Note:
When turning on the power right after it is set to the stand-by mode, wait a few sec-
onds.
„ To change the display brightness (2 levels)
When the power is on, you can switch the display brightness by pressing the DIS-
PLAY button on the remote control.
„ Volume control
Press the VOLUME (+ or -) button to increase or decrease the volume.
„ Bass control
„ Treble control
„ Surround
Press the SURROUND button to enjoy music that seems to surround you. "SUR-
ROUND" will appear.
To cancel the surround mode, press the SURROUND button again.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
For example, CD function
Dimmer on Dimmer off
1 Press the BASS/TREBLE button to select "BASS".
2 Within 3 seconds, press the VOLUME (+ or -) button to adjust the bass.
1 Press the BASS/TREBLE button to select "TREBLE".
2 Within 3 seconds, press the VOLUME (+ or -) button to adjust the treble.
SURROUND indicator "SURROUND" will go out.
2 1 39 40 0 .....
+5 -5
+5 -5