Locking the operation buttons on the, Projector (keylock function) – Sharp Notevision XG-MB67X-L User Manual

Page 52

Input screen for keycode

• You can not use the following buttons for

keycode:
• S STANDBY/ON
• f ON
• e STANDBY
• h ENTER
• l RETURN
• B MENU/HELP

• System lock function recognizes each

button on the remote control or on the
projector as an individual button, even
if they share the same button name. If
you used the buttons on the projector
in setting your keycode, the keycode
cannot be canceled with the remote
control.

Press the 4 buttons on the remote
control or on the projector to en-
ter the new keycode in “New
Code”.

Note

Menu operation n Page

Locking the Operation
Buttons on the Projector
(Keylock Function)

Use this function to lock the operation
buttons on the projector.

a Taking the Keylock off

Hold down T ENTER on the projector for
about 5 seconds.

ROn-screen Display

a Locking the Operation Buttons

Hold down T ENTER on the projector for
about 5 seconds while the projector is being
turned on.

ROn-screen Display

• The keylock function does not affect the op-

eration with the remote control buttons.

• You cannot use the keylock function while the

projector is warming up.

• When the projector is in standby mode, you

can release the keylock by holding down
T ENTER and S STANDBY/ON on the pro-
jector simultaneously for about 5 seconds.

• Keylock does not function while the projector

is: displaying the “Setup Guide” or “Menu”
screens, in standby mode, warming up,
changing input signals, operating “Auto Sync”
function, in “FREEZE” mode or on the “Sys-
tem Lock” screen during warming up.

Info

Adjusting the Projector Function (“PRJ - ADJ” menu) (Continued)

Note

To cancel the keycode that you have already
set

• Press R on the projector for four times in steps

2 and 3 above.

When the System Lock is set

• When System Lock is set, the keycode input

screen appears after the power is turned on.
When it appears, enter the right keycode to
start projection.

Enter the same keycode in “Re-
confirm”.

Setting the System Lock

PRJ - ADJ

Old Code

New Code

Reconfirm

* * * *

–

– – –

– – – –

System Lock

– – – –

XG-MB67XL_EN_CD_k

06.9.11, 6:50 AM