Sharp Notevision XG-MB67X-L - Manual (Page 30)

26
Controlling the Projector by a Computer
When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS-
232C adaptor and an RS-232C serial control cable (cross type, commercially available), the com-
puter can be used to control the projector and check the status of the projector. Refer to the “SETUP
MANUAL” contained on the supplied CD-ROM for details.
When connecting to a computer using an RS-232C serial control cable and a DIN-
D-sub RS-232C adaptor
To RS-232C terminal
To RS-232C terminal
DIN-D-sub RS-232C
adaptor
RS-232C serial control cable (cross type, commercially available)
Note
• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the
operation manual of the computer for details.
• Refer to page 3 of the “SETUP MANUAL” contained on the supplied CD-ROM for “RS-232C Speci-
fications and Commands”.
Info
• Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This
may damage your computer or projector.
• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on.
This may damage your computer.
Computer
DIN-D-sub
RS-232C
adaptor Supplied
accessory
XG-MB67XL_EN_CD_g 06.9.11, 6:46 AM 26