Sony CMT-LS1 - Manual (Page 9)

9
Getting Started
Step 2: Setting the time
You must set the time before you can use the
timer functions.
The clock is on a 24-hour system for the European
model, and a 12-hour system for other models.
The 24 hour system model is used for illustration
purposes.
Set the time before turning on the power.
–
+
– +
>10 10/0
8 9 7
5 6 4
2 3 1
m M
–
+
x
. >
N X
1
2,3
2,3
1
Press CLOCK/TIMER SET while the
power is off.
The hour indication flashes.
2
Press +/– to set the hour then press
ENTER.
The minute indication flashes.
3
Press +/– to set the minute then press
ENTER.
The clock starts.
To change the time
You can change the preset time while the power is
on.
1 Press CLOCK/TIMER SET.
2 Press +/– repeatedly until “SET CLOCK”
appears then press ENTER.
3 Repeat steps 2 and 3 of “Setting the time”.
Tips
• If you have made a mistake, start again from step 1.
• The built-in clock shows the time in the display
while the power is off.
• The upper dot flashes for the first half of a minute
(0 to 29 seconds), and the lower dot flashes for the
last half of a minute (30 to 59 seconds).