Sony ICF-CD2000 - Manual

Owner’s Record
The serial number is located at the bottom.
Record the serial number in the space provided
below. Refer to them whenever you call upon
your Sony dealer regarding this product.
Model No. ICF-CD2000
Serial No.
WARNING
To prevent fire or shock
hazard, do not expose
the unit to rain or
moisture.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
INFORMATION
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/
TV technician for help.
CAUTION
The use of optical instruments with this
product will increase eye hazard.
3-865-826-22 (1)
Sony Corporation  1999 Printed in Malaysia
FM/AM CD Clock Radio
Operating Instructions
ICF-CD2000
Power Sources
The unit cannot be played on manganese
batteries. Use only alkaline batteries.
Installing the Lithium
Battery for Clock Backup
1 Insert a pointed object into the hole
beside the lithium battery compartment
to eject the tray.
PUSH
2 Place the lithium battery CR 2025 on
the tray with the e side facing up, and
slide the tray into the compartment
until you hear a click.
Note
The lithium battery is only for clock backup. The
unit cannot play a CD or the radio unless it is
powered by alkaline batteries or the AC power
adaptor.
Replacing the lithium battery
The battery life of the backup lithium battery is 3
months when both the alkaline batteries or house
current are not connceted. The lithium battery
will last longer with these power sources, since
either source will supply power for clock backup
as well.
If the clock flashes “AM 12:00” when you replace
the alkaline batteries, the lithium battery is
exhausted. Replace the lithium battery.
Reset the clock and the station presets if needed.
Notes on batteries
• Keep the lithium battery out of reach of
children. Should the battery be swallowed,
consult a doctor immediately.
• Wipe the batteries with a dry cloth to assure
good contact.
• Be sure to install the batteries in the correct
polarity position.
• Do not hold the batteries with metallic
tweezers, as doing so may cause a short-circuit.
• Do not break up the batteries or throw them
into a fire, which might cause them to explode.
Carefully dispose of used batteries.
CAUTION
Danger of explosion if battery is replaced
incorrectly. Replace only with the same or
equivalent type recommended by the equipment
manufacturer. Discard used batteries according
to manufacturer's instructions.
Installing Alkaline
Batteries
1 Slide the battery compartment lid in the
direction of the arrow and lift it up.
2 Install four size AA (LR6) alkaline
batteries with correct polarity.
Insert the batteries with the polarity as
shown in the diagram at the bottom of the
unit. Be sure to insert the batteries from the
E
terminal.
Battery life
Using Sony alkaline size AA (LR6)
CD (ESP on) Approx. 7 hours
Radio Approx. 17 hours
Replacing batteries
• When the batteries become weak, “E” flashes
in the display. When the batteries are
exhausted, “E” stops flashing and remains in
the display. Replace all the four batteries with
new alkaline batteries of the same kind.
• When “E” is lit in the display, the unit stops
all operation. Only the clock display will
appear in the display. After replacing the
batteries, press CD u or RADIO•SLEEP so that
“E” disappears in the display.
When the battery compartment lid
becomes detached
The battery compartment lid is designed to
become detached if opened with excessive force.
In such a case, reattach it as shown below.
1
2
Note
When the unit is not being used for a long period
of time, remove the batteries to avoid damage
from battery leakage and corrosion.
Using House Current
Connect the supplied AC power adaptor
to the DC IN 6V jack, and plug it into a
wall outlet.
Be sure to plug in the adaptor securely to both
the DC IN 6V jack and to the wall outlet. The
unit automatically switches to external power
even with the batteries inserted.
Notes
• When using the unit on AC power, we
recommend that you remove the dry batteries
to avoid possible battery leakage.
• When the AC power adaptor is not to be used
for a long period of time, be sure to unplug it
both from the DC IN 6V jack and from the wall
outlet.
• Do not remove the lithium battery even when
operating the unit on house current, as it serves
as backup power for the memory.
• If power from the AC power adaptor is
disrupted due to power interruption, etc., the
unit switches to battery power when available.
• Use only the supplied Sony AC power adaptor.
Using any other adaptor may cause damage to
the unit.
Polarity of the plug
Push
Specifications
CD player section
System
Compact disc digital audio system
Laser diode properties
Material: GaAlAs
Wavelength: 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW
(This output is the value measured at a
distance of about 200 mm from the objective
lens surface on the optical pick-up block with
7mm aperture.)
Frequency response
20-20,000 Hz +1 –1.5 dB
Wow and flutter
Below measurable limit
Radio section
Frequency range
Band Frequency Channel step
FM 87.5-108 MHz 0.1 MHz
AM 530-1,710 kHz 10 kHz
FM 87.5-108 MHz 0.05 MHz
AM 531-1,710 kHz 9 kHz
General
Time display
12-hour system
Speaker
Full range: 4 cm (1 5 / 8 inches), 8 ohms (2)
Output
i (headphones) jack (stereo minijack, 3.5 mm
dia.)
Power output
200mW + 200mW (at 10% harmonic
distortion)
Power requirements
Main unit:
• 6V DC, four size AA (LR6) alkaline
batteries
• DC IN 6V jack accepts supplied AC power
adaptor for use with 120 V AC, 60 Hz
Backup for Clock: 3V DC, one CR 2025
lithium battery
External power source
DC IN 6V
Dimensions
Approx. 166.5 Ч 34 Ч 173 mm (w/h/d)
(Approx. 6 5 / 8
Ч 1 3 / 8
Ч 6 7 / 8 inches)
incl. projecting parts and controls
Mass
Approx. 660 g (1 lb 7 oz) incl. batteries
Supplied Accessories
Sony CR 2025 lithium battery (1)
AC power adaptor (1)
Stereo headphones (1)
Design and specifications are subject to change
without notice.
Before You Begin
Thank you for choosing a Sony CD clock radio!
It will give you many hours of reliable service
and listening pleasure.
Before operating the CD clock radio, please read
these instructions thoroughly and retain them for
future reference.
Features
• PLL (Phase Locked Loop) synthesized travel
clock radio with CD player.
• Wake up to your choice of alarm sound source
— CD (with selectable Wake-up track), radio
(with selectable Wake-up station), or buzzer.
• Clock function for the traveller
— display the time in your destination with
the WORLD time function.
— display both the current time and the alarm
time with the dual display.
• Simple radio operation with the Auto Station
Scan tuning and preset tuning. Preset tuning
stores up to 15 (10 FM, 5 AM) stations.
• Multi-functioned CD player — variety of
playback modes (repeat, shuffle, etc.) plus a
10-second Electronic Shock Protection
function to prevent skipping of sound.
• Stereo output from both the speakers and the
headphones.
Note on AM channel step
The AM channel step differs depending on areas.
The channel step of this unit is factory-set to
10 kHz. Switch the channel step when using the
unit in areas with the 9 kHz frequency allocation
system (see “Changing AM Channel Step”).
Area Channel step
North and South 10 kHz
American countries
Other countries
9 kHz
Precautions
• Operate the unit on the power sources
specified in “Specifications.”
• The nameplate indicating voltage, etc. is
located at the bottom.
• Disconnect the AC power adaptor cord by
grasping the plug. Never pull it by the cord.
• Do not leave the unit in a location near a heat
source such as a radiator or airduct, or in a
place subject to direct sunlight, excessive dust,
mechanical vibration, or shock.
• Allow adequate air circulation to prevent
internal heat build-up. Do not place the unit on
a surface (a rug, a blanket, etc.) or near
materials (a curtain) which might block the
ventilation holes.
• Should any liquid or solid object fall into the
unit, unplug (or remove batteries from) the
unit and have it checked by a qualified
personnel before operating it further.
• When the casing becomes soiled, clean it with a
soft cloth dampened with a mild detergent
solution. Never use abrasive cleansers or
chemical solvents, as they may mar the casing.
• The unit is not disconnected from the AC
power source (mains) as long as it is connected
to the wall outlet, even if the unit itself has
been turned off.
If you have any question, please consult your
nearest Sony dealer.
Notes on Headphones
Road safety
Do not use headphones while driving, cycling, or
operating any motorized vehicle. It may create a
traffic hazard and is illegal in many areas. It can
also be potentially dangerous to play your
headphones at high volume while walking,
especially at pedestrian crossings. You should
exercise extreme caution or discontinue use in
potentially hazardous situations.
Preventing hearing damage
Avoid using headphones at high volume.
Hearing experts advise against continuous, loud
and extended play. If you experience a ringing in
your ears, reduce volume or discontinue use.
Caring for others
Keep the volume at a moderate level. This will
allow you to hear outside sounds and to be
considerate to people around you.
Troubleshooting
Should any problem occur with the unit, make
the following checks to determine whether or not
servicing is required. If the problem persists,
consult your nearest Sony dealer.
There is no radio or CD sound.
• The batteries are exhausted. Replace all
batteries when “E” appears in the display.
• The batteries are not inserted with correct
polarity.
• The AC power adaptor is not plugged in
properly.
• The volume is not adjusted properly.
• The headphones are plugged into the i
(headphones) jack when you are trying to
listen through the speakers.
• The disc is not placed correctly.
The CD player does not operate.
• The batteries are exhausted. Replace all
batteries when “E” appears in the display.
• The disc is not placed correctly (the labeled
surface should face up).
• The CD compartment lid is not completely
closed.
• The CD is dusty or defective. Clean the disc
with an optional cleaning cloth. Wipe the disc
from the center out.
The CD sound skips.
• The CD is dusty or defective. Clean the disc
with an optional cleaning cloth.
• The pickup lens is dirty. Clean the lens with a
commercially available blower.
• The unit is exposed to vibration.
• Activate the ESP function.
The CD, radio or buzzer alarm does not come
on at the preset time.
• The current time is not set correctly.
• The alarm time is not set correctly.
• An alarm mode has not been selected.
• The disc has not been placed (for CD alarm).
• The CD compartment lid is not completely
closed.
• The volume is not adjusted properly.
The clock flashes “AM 12:00” and the station
presets are erased.
• The lithium battery is exhausted. Replace it.
Bottom
CR2025
Bottom
to wall outlet
AC power
adaptor
(supplied)
to DC IN 6V