Schumacher XC103 - Manual (Page 11)

• 7 •
CHARGER CONTROLS 10.
1
2
3
Charge Rate Button 1.
Battery Type Button 2.
Digital Display 3.
LED Indicators
CONNECTED (red) LED lit: Indicates that the charger is properly
connected to the battery.
CHARGING (yellow) LED lit: Indicates the charger has detected a battery
and is charging it.
CHARGED (green) LED lit: Indicates the battery is fully charged and the
charger is in maintain mode .
NOTE: See the Operating Instructions section for a complete description of the
charger modes.
Digital Display
The Digital Display gives a digital indication of voltage, % of charge or time,
depending on the Display Mode chosen.
Display Mode Switch
The display will show the battery VOLTAGE when the charger is not charging
a battery. When it goes into charging mode, the display will automatically
change to ON (to show charging has started) and then show the percent-of-
charge of the battery being charged and either 6 or 12 (the voltage the charger
determined the battery is). If you manually stop the charging process (by
pressing the CHARGE RATE button) before the battery is fully charged the
display will show OFF.
Battery % • - The digital display shows an estimated charge percentage of
the battery connected to the charger battery clips.
Voltage –
• The Digital Display shows the voltage at the charger battery clips
in DC volts, or the voltage the charger detects the battery has depending on
what mode the charger is in.