Sub-Zero Sub-Zero EN - Manual (Page 9)

Wine Storage Use & Care 9
subzero.com
Electronic Control System
LED DISPLAY
Electronic control system functions, such as digital
temperatures and service indicators, are shown in the LED
display, located on the control panel. The temperatures of
each zone will be visible through the glass door of your
wine storage unit. If you are using your unit frequently, the
numbers may fluctuate.
UNIT ON/OFF
The UNIT ON/OFF key pad on the control panel will shut
off all electrical power to the wine storage unit for cleaning
or service.
LIGHTS ON/OFF
All wine storage units have the capability of having the
lights on independently of the door’s opening and closing.
This will allow you to display your collection of wine for
special occasions.
To have the lights remain on independently of the door’s
opening and closing, press the LIGHTS ON/OFF key pad.
Press the key pad again to have the lights to go off when
the door is closed.
ALARM FEATURE
If the microprocessor detects temperature fluctuations or
a faulty component, you will hear an audible beep and a
bell symbol will flash in the LED display on the control
panel. Also, if the unit is tied in with your home security, it
will alert this system. You can deactivate the alarm feature
and the audible sound by depressing the BELL symbol
key pad. If the alarm is deactivated, the bell will not be
visible in the LED display.
SABBATH MODE (STAR-K)
All wine storage units feature the Sabbath mode. This is
for certain religious observances where the lights need to
be turned off.
To initiate Sabbath mode, while the unit is on press the
UNIT ON/OFF key pad so that OFF is visible in the LED
display on the control panel. Your unit will be off.
Then press and hold the UNIT ON/OFF key pad for 10
seconds. This will turn the unit back on and will disable
the lights. To return the unit to normal lighting, press and
release the UNIT ON/OFF key pad.
If you have questions about Star-K compliance, visit
www.star-k.org.
VISUAL SERVICE DISPLAY
The electronic control system monitors temperatures as
well as the unit’s operation. If there is a temperature or
operation problem, you will notice the word SERVICE
illuminated in the LED display on the control panel. Before
calling for service, please check to see if your condenser
area needs cleaning. Refer to condenser cleaning on
page 17.
You should not leave the lights on overnight or for
extremely long periods of time. The heat from the
lights will cause the unit to work unnecessarily hard.