Smart Technologies SMARTBoard 480iv - Manual (Page 72)

The following table describes the power state commands:
Command Description
on Turns on the projector.
off Starts the shutdown process. A dialog box appears with the
message, “Press Power Button to Turn off Projector.” You must send
a second Off command within 10 seconds to put the projector into
Standby mode.
off now Shuts down the projector immediately. You can’t delay or cancel this
command.
get powerstate Indicates the projector’s current power state.
The following table describes the power state fields:
Field Description
Powering The projector is turning on.
On The projector is on.
Cooling The projector is cooling.
Confirm off Confirm off is a non-selectable power state that is returned during
stage one of the two-button Off sequence.
Idle The projector is off but still receiving power (Standby mode).
Source selection controls
These commands switch input sources. The source type determines which commands can be
accepted.
Command Response Available in Standby
mode
get input input=[field] Yes
set input=[field] input=[field] No
The following table describes the source selection commands:
Command Description
get input Returns the projector’s current input.
set input=[field] Returns the input to one of the selectable fields.
The following table describes the source selection response fields:
Field Description
VGA1 Switches source to the VGA 1 input connector.
Composite Switches source to the Composite video connector.
S-Video Switches source to the S-Video input connector.
None A non-selectable value that appears when you enter a “get input”
command while the projector is in Standby mode.
A P P E N D I X A
Remotely managing your interactive whiteboard system
62