Smart Technologies SMARTBoard 480iv - Manual (Page 5)

l
Do not block the projector’s ventilation slots and openings.
l
Avoid putting the projector into Standby mode during the lamp ignition phase because this
can lead to premature lamp failure. Keep the projector lamp on for a minimum of 30 minutes
before putting it into Standby mode to preserve the lamp life.
l
In a high altitude location over 1800 m (6000'), where the air is thin and cooling efficiency is
reduced, use the projector with the fan mode set to High.
l
Cycling power to the projector repeatedly can lock or damage your SMART product. After
you put the product into Standby mode, wait at least 30 minutes for cooling before starting
the product again.
l
Do not adjust any settings in the service menu other than those listed in the following
procedures. Changing other settings might damage or affect the operation of your projector
and may invalidate your warranty.
l
Before you clean the SMART V25 projector, press the Power button twice on the
Extended Control Panel (ECP) or remote control to put the system into Standby mode, and
then allow the lamp to cool for 30 minutes.
l
Do not spray cleaners, solvents or compressed air near any part of the projector because
they can damage or stain the unit. Spraying the system could spread a chemical mist on
some of the projector’s components and lamp, resulting in damage and poor image quality.
l
Do not allow liquids or commercial solvents of any kind to flow into the projector.
l
When transporting your SMART product, repack it with as much of the original packaging as
possible. This packaging was designed with optimal shock and vibration protection.
l
If your SMART product requires replacement parts, make sure the service technician uses
replacement parts specified by SMART Technologies or parts with the same characteristics
as the original.
I M P O R T A N T I N F O R M A T I O N
iii