Sierra Wireless WISMO218 - Manual (Page 88)

WA_DEV_W218_PTS_002 Rev 005 Page 88 of 109
Product Technical Specification &
Customer Design Guidelines
Equipment Configuration
The communication tester is set according to the WISMO218 operating mode.
Paging during idle modes, TX burst power, RF band and GSM/DCS/GPRS may be selected on the
communication tester.
Listed in the table below is the network analyzer configuration according to operating mode:
Table 41. Operating Mode Information
Operating Mode Communication Tester Configuration
OFF Mode N/A
Alarm Mode N/A
Idle Mode
Paging 9 (Rx burst occurrence ~2s)
Paging 2 (Rx burst occurrence ~0,5s)
Connected Mode
900 MHz
PCL5 (TX power 33dBm)
PCL19 (TX power 5dBm)
1800MHz
PCL0 (TX power 30dBm)
PCL15 (TX power 0dBm)
GPRS
Transfer Mode class 8
(4Rx/1Tx)
900 MHz
Gam.3 (TX power 33dBm)
Gam.17 (TX power 5dBm)
1800MHz
Gam.3 (TX power 30dBm)
Gam.18 (TX power 0dBm)
Transfer Mode class 10
(3Rx/2Tx)
900 MHz
Gam.3 (TX power 33dBm)
Gam.17 (TX power 5dBm)
1800MHz
Gam.3 (TX power 30dBm)
Gam.18 (TX power 0dBm)
The standalone power supply may be set from 3.2V to 4.8V.
The power supply (VBATT) used for measurement may be set from 3.2V to 4.8V according to the
WISMO218 VBATT specifications.