Sennheiser EM 3732 User Manual
Page 82
34
The operating menu
Starting the scan
Scan new
Via the “
Scan new
” menu, you can scan all frequency banks for free
channels. The last scan result is overwritten.
̈
Before starting the scan, switch all transmitters of your system
off
,
since channels used by switched-on transmitters will not be displayed
as “free channels”.
̈
Turn the jog dial
7
until the arrow points to
“
Scan new
”.
̈
Press the jog dial
7
to start the scan.
The receiver scans the frequency banks one after the other for free
channels. This can take several minutes. After the scan, a table displays
the number of free channels for each frequency bank and the green
backlighting of the
save
button
8
flashes.
Note:
You can cancel the scan at any time by pressing the
esc
button
6
. The
display changes to the setting mode of the “
Scan
” menu and the last
scan result is restored.
̈
Turn the jog dial
7
to select a frequency bank with a sufficient number
of free channels.
̈
Press the
save
button
8
.
The selected frequency bank is automatically called up in the “
B.Ch
”
menu.
̈
Select a channel from this frequency bank (see “Selecting a frequency
bank and a channel” on page 28).
Note:
After the scan, the channels that are occupied or subject to interference
are marked with a warning triangle and the text “
Freq. occupied
” in the
“
Tune
” menu.
Channel list
Scan new
Scan reset
esc
s
ave
syn
c
digital audio
processing
syn
c
DEV
M
H
z
790.800
03.03
BANK
CH
COM
AF
B.Ch
1
.
790.800
MHz
Freq. occupied
EM3732_516551_0108_Sp6.book Seite 34 Dienstag, 18. Dezember 2007 11:55 11