SIIG CYBER 1S1P PCI - Manual (Page 9)

9
Changing Parallel Port Address (LPT)
Some parallel devices need a specific parallel port in
order to work. If your parallel device works properly, do
not change this setting.
Windows 95/98/98SE/ME
1. From the Device Manager window double click
Ports (COM & LPT), then double click CyberParallel
PCI.
2. Click Settings tab, check Enable use of I/O location
278h.
3. Click OK, click OK again to close Device Manager,
and click Yes to restart Windows to save the changes.
Windows 2000/XP/Server 2003
1. From the Device Manager window double click
Ports (COM & LPT), then double click CyberParallel
PCI....
2. Click Port Settings tab.
3. At the LPT Port Number box, click the down arrow
and select an LPT port that is not in use.
4. Click OK, then close Device Manager to save the
changes.