SIIG 04-0322B - Manual (Page 8)

8
Windows 2000 Driver Installation
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the contents of the Floppy folder, found on the
driver CD, onto a blank floppy disk then follow the
directions below.
For New Windows 2000 Installation
1.
Install the board and follow Microsoft procedures
to install Windows 2000 accordingly.
2. Restart your system when prompted during
Windows' installation.
3. At the Windows 2000 Setup screen, press F6 to
install the driver.
4. Insert the driver diskette. Press S, then press Enter.
5. Select Silicon Image SiI 3114 ... Controller for
Windows NT 4.0 and 2000 , and press Enter.
6. Press Enter to continue and follow on-screen
instructions to complete the installation.
For Existing Windows 2000 Installation
1.
Install the board and boot up Windows 2000.
2. At the Found New Hardware Wizard, click Next.
3. Select Search for a suitable driver for my device
(recommended) and click Next.
4. Insert the driver CD, check CD-ROM drives, uncheck
the other boxes, and click Next. Click Next again to
continue.
Note : If a warning message pops up, click Continue
Anyway , then click Finish. Our driver has been
thoroughly tested in Windows for stability.
5. Click Finish, remove the driver CD and restart
Windows to complete the driver installation.