SIIG 04-0322B - Manual (Page 4)

4
Note : If you like to monitor disk activity of the
Serial ATA hard drives, you may at this time connect
the hard disk LED of the system case to the Hard
Disk LED Pins
on the Serial ATA controller, see
figure 1 , on page 2 for the location of the pins. For
most systems connect the red wire to the pin farthest
from the mounting bracket.
6. Replace the computer cover and reconnect the power
cord. Go to Software Installation to install the Serial
ATA 4-Channel PCI device driver.
Software Installation
This section provides information on how to install the
Serial ATA 4-Channel PCI drivers for the following
operating systems:
New & Existing Windows 98/98SE
New & Existing Windows ME
New & Existing Windows NT 4.0
New & Existing Windows 2000
New & Existing Windows XP/Server 2003
Windows 98/98SE Driver Installation
For New Windows 98 Installation
1.
Install the board and follow Microsoft procedures
to install Windows 98 accordingly.
2. Once Windows has been installed, right click My
Computer
and click Properties. Select Device
Manager tab.
3. Double click PCI Mass Storage Controller listed
under Other Devices.
4. Select Driver tab, then click Update Driver button.