Sony ICF-SC1PC - Manual (Page 35)

Precautions
*Operate the scanning receiver only on recommended power
sources. To use the receiver on AC power, use only the supplied
or the recommended AC power adaptor. Do not use any other
AC power adaptor. To use the receiver on a car battery, use only
the recommended car battery cord. Do not use any other car
battery cord.
*The nameplate indicating the operating voltage, power
consumption, etc. is located at the bottom exterior of the receiver.
*Should any solid object or liquid fall into the set, remove the
batteries and have the receiver checked by qualified personnel
before operating it any further.
*Reception may be difficult or contain noise in vehicles or in
buildings. Try listening near a window.
*Certain frequencies may be difficult to receive due to internal
spurious signals, or birdies, inherent to the built-in oscillators
used in a receiver. If the scanning receiver always pauses
scanning at a certain frequency but seems to be receiving no
signal, it may be receiving a birdie. In this case, designate it a
SKIP-frequency.
*Be sure to adjust VOL to a moderate level before turning on the
power or plugging in the earphone. There will be no sound when
the receiver is scanning. Sudden reception (opening of the
squelch) may cause unexpected loud sound and may cause
hearing damage.
*If there is lightning when you are using an external antenna,
disconnect AC power immediately from the wall outlet (if
connected). Never touch the antenna during a lightning storm.
On batteries
Do not carry the batteries with coins or other metallic objects. It
can generate heat if the positive and negative terminals of the
batteries are accidentally contacted by a metallic object.
On handling
l
When carrying the receiver, do not hold it by the antenna, the
VOL control, or the SQL control.
‘Do not bend or pull the antenna.
*Do not drop the receiver or expose it to mechanical shock. It may
cause a malfunction.
*Do not leave the unit in a location near heat sources, or in a place
subject to direct sunlight, excessive dust or sand, moisture, rain,
mechanical shock, or in a car with its windows closed.
*The LCD display may become hard to see or slow down when
using the unit at high temperatures (above 40'C/104'F) or at low
temperatures (below O'C/32'F). At room temperature, the
display will return to its normal operating condition.
On cleaning
When the case becomes soiled, clean it with a soft cloth dampened
with a mild detergent solution. Never use abrasive cleansers or
chemical solvents, as they may mar the case.
If you have any questions or problems concerning your
scanning receiver, please consult your nearest Sony
dealer.
35