Sony ICF-SC1PC - Manual (Page 2)

To prevent fire or shock hazard, do not expose
the unit to rain or moisture.
To avoid electrical shock, do not open the
cabinet.
Refer servicing to qualified personnel only.
Owner’s record
The model and serial numbers are located at the bottom of
the receiver. Record them in the space provided below.
Refer to them whenever you call your Sony dealer
I
regarding this product.
Model No.
Serial No.
WARNING
You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.
Use of this scanning receiver in a motorized vehicle may
be unlawful or require a permit in certain areas. Contact
your local law enforcement authorities for more
information.
The Federal Electronic Communications Privacy Act
as amended, prescribes intentionally listening to,
using, or disclosing the contents of a cellular or cordless
telephone transmission as illegal.
This scanning receiver excludes the cellular phone band
from its frequency range. Any modification of this
receiver to the contrary is likewise illegal by the ECPA.
Information (for ICF-SC1PC)
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
2
technician for help.