Sony ICF-SC1PC - Manual (Page 23)

. ..then press EXE (without releasing ENTER).
P A G E
5
DELAY
Channel 26 has been entered and presetting is
complete. The display returns to the reception
display.
To cancel presetting input
Release ENTER.
change the page number and channel number input, you can
also use the +/-keys when the number is flashing in the display
(i.e.; while holding down ENTER).
*If the page number flashing in the display is already the one of
your choice when you hold down ENTER, you do not need to
press the page number again; press EXE to enter.
*After the page number has been entered, the receiver will first
display the number of the lowest unoccupied channel.
Therefore, when you are presetting stations the first time around
on a particular page, the receiver will automatically start from
channel number 1 and move up in order every time you preset a
station, without having to input the channel number manually.
Notes
*The “10/0” key functions as 10 for the page number, but as 0 for
anything else. To input page number 10, press the “10/0” key. To
input channel number 10, press “1” and then “10/0”.
*If there is no unoccupied preset channel on the page you have
chosen, “PRESET - -” will flash in the display.
*If you preset a frequency on a channel that already has a preset
frequency, the older frequency will be overwritten by the new
one.
l
When you preset a frequency, the DELAY setting (see “Adjusting
scanning pause time”, page 30) for the particular frequency is
memorized as well.
To change the DELAY setting for a preset frequency, first recall
the preset frequency (see “Recalling a preset channel” below),
then press PRI/DELAY for one second or longer. The new
DELAY setting will be memorized along with the preset
frequency (DELAY will turn on if it had been off, vice versa).
*You cannot preset a station you have received with Memory
Scanning, whether or not the receiver is in scanning pause.
*You cannot preset a priority channel frequency you have
received with Priority Scanning.
Recalling a preset channel
1
Press POWER to turn the receiver on.
2 If you are in the Scanning Mode, press SCAN to enter
the Manual Mode.
will disappear from the display.
3 Press PAGE, then the number key for the page
number you wish to recall, then EXE.
4 Press PRESET, then the number key for the preset
channel number you wish to recall, then EXE.
23