Sony ICF-SC1PC - Manual (Page 10)

Receiving in the Scanning Mode
Band Scanning
The receiver divides its frequency range (25.0 MHz to
1300.0 MHz) into 17 bands. Band Scanning scans one of
these bands step by step.
Set the SQL control to MIN.
Press POWER to turn the receiver on.
Turn VOL to adjust the volume.
Press BAND repeatedly to choose a band.
With each press, the lowest frequency of the next
band will be displayed. Press repeatedly until the
display shows the lowest frequency of the band of
your choice.
Adjust the SQL control (see page 11).
Scanning will start.
When the receiver receives a signal,
will light
up and the receiver will go into scanning pause. When
the signal breaks off, the receiver will resume
scanning automatically.
To turn off the power
Press POWER.
Frequency range of the bands
Frequencyrange
(MHz)
25.0 ~ 29.0
29.0 ~ 54.0
Step Detection Mode
5kHz AM
5kHz N F M
54.0 ~ 72.0 50kHz WFM
72.0 ~ 76.0 5kHz NFM
76.0 ~ 88.0 50kHz WFM
88.0 ~ 108.0 100kHz WFM
108.0 ~ 137.0 12.5kHz AM
137.0 ~ 148.0 5kHz NFM
148.0 ~ 174.0 5kHz NFM
174.0 ~ 216.0 50kHz WFM
216.0 ~ 225.0
5kHz NFM
225.0 ~ 400.0 12.5kHz AM
400.0 ~ 470.0 12.5kHz NFM
470.0 ~ 512.0 12.5kHz NFM
512.0 ~ 806.0 50kHz WFM
806.0 ~ 1000.0 12.5kHz NFM
(excluding cellularphone band)
1000.0 ~ 1300.0 12.5kHz NFM
(AM: Amplitude Modulation. NFM: Narrow Band Frequency
Modulation. WFM Wide Band Frequency Modulation)
10