Sony 3-213-480-12(1) - Manual (Page 19)

19
H
ook
ups
and
Se
tti
n
gs
A Connecting to audio L/R jacks
This connection uses a stereo amplifier’s
(receiver’s) two front speakers for sound.
You can enjoy the surround function that creates
virtual speakers from two stereo speakers. Select
“Surround1,” “Surround2,” or “Surround3” in
“Surround” of “Audio” setup (page 106).
Surround 1
Surround 2
Surround 3
Note
Make sure that your listening position is between and at
an equal distance from your speakers, and that the
speakers are located in similar surroundings.
B Connecting to a digital audio input jack
Use this connection if your AV amplifier
(receiver) has a Dolby
*1 Digital, DTS *2 , or MPEG
audio decoder and a digital input jack. You can
enjoy the surround effect of Dolby Digital (5.1ch),
DTS (5.1ch), or MPEG audio (5.1ch).
*1 Manufactured under license from Dolby Laboratories.
“Dolby” and the double-D symbol are trademarks of
Dolby Laboratories.
*2 “DTS” and “DTS Digital Out” are trademarks of DTS,
Inc.
z Hints
• For correct speaker location, see the operating
instructions supplied with the connected components.
• Digital audio signal can also be output when playing a
VHS tape.
Notes
• During DVD recording, you cannot hear VHS sound
by pressing VIDEO, as the DIGITAL AUDIO OUT
jacks or HDMI OUT jack will output DVD audio
signals only.
• After you have completed the connection, make the
appropriate settings in Easy Setup (page 23). If your
AV amplifier (receiver) has an MPEG audio decoder
function, set “Digital Out” – “MPEG” to “MPEG” in
the “Audio” setup (page 105). Otherwise, no sound or
a loud noise will come from your speakers.
• With a coaxial or optical digital connection, you cannot
use the virtual surround effects of this recorder.
• When outputting from the DIGITAL AUDIO OUT
jacks, you cannot switch the bilingual sounds on a
DVD-RW (VR mode) or DVD-R (VR mode) by
pressing AUDIO.
• When you connect the recorder to an AV amplifier
(receiver) using an HDMI cord, you will need to do one
of the following:
– Connect the AV amplifier (receiver) to the TV with
an HDMI cord.
– Connect the recorder to the TV with a video cord
other than HDMI cord (component video cord,
S VIDEO cord, or audio/video cord).
Virtual speaker