Operations, Control panel – Woodstock W1737 User Manual
Page 18
-16-
W1737/W1738 Owner's Manual (Mfg. 10/09+)
O
PE
R
ATIO
NS
OPERATIONS
Figure 16. Control panel interface.
Control Panel
Below is a summary of your sander control panel and
the components that it controls. Use the list with
Figure 16 to become familiar with your sander.
•
Sanding Load Amp Meter:
Indicates the current amp load on the sanding
motor when a sanding operation is in progress.
•
Sanding Belt Start and Stop Buttons:
Turns the sanding motor
ON
and
OFF
if
the sander has air pressure and the belt is
tensioned.
•
Run LED: Indicates the conveyor lift motor is
operating.
•
Input LED: Indicates the sander is waiting for
new numerical dimension values.
•
Digital Readout: Displays current sander
settings.
•
Table Up and Down Keys:
Manually cycles the table lift motor to raise and
lower the table.
•
SET Key: Press and hold the SET button for
3 seconds to calibrate display at the current
board thickness; or press and hold key for
10 seconds to toggle the display between
metric and standard measurement.
•
Feed Belt Start and Stop Buttons: Cycles
the conveyor motor
ON
and
OFF
for
feeding wood into the sander.
•
Power Lamp: Indicates when machine has
power to the control panel.
•
Emergency Stop Button: Stops all electrical
power to motors in event of emergency,
and stops sanding drums with an air-disc
brake.
•
Table Start and Stop Keys: Cycles the table
lift motor in and out of the automatic raise
and lower function.
•
Key Pad: Allows you to input your numerical
sanding specifications for automated
sanding control.
Sanding
Load
Amp
Meter
Sanding
Belt Stop
Button
Table
Start
Key
Table
Stop
Key
Table
Down
Key
Table
Up
Key
Table
Set
Key
Key
Pad
Feed
Belt
Stop
Button
Emergency
Stop
Button
Power
Lamp
Feed
Belt
Start
Button
Digital
Readout
Sanding
Belt
Start
Button
Run
LED
Input
LED