Siemens MT50 - Manual (Page 18)

Making a phone call
16
MT50 english, A31008-H5120-A1-1-7619 (4. März 2002, 10:58)
©
S
ieme
ns A
G
20
01,
I:
\M
O
BI
L\K
45\
MT
50
-M
an
ta
-a
lt
es
D
es
ig
n\EN
G
-
Conference
Call up to 5 parties one by one and
link them together in a phone con-
ference. Some of the functions de-
scribed may not be supported by
your service provider or must be
enabled specifically.
You have established a connection:
§Hold§ The current call is put on
hold. Now dial a new
number. When the new
connection is estab-
lished...
; menu§ ... open menu and select
Conference . The held call is
joined.
Repeat procedure until all partici-
pants are linked together (up to
5 participants).
End
S All calls in the conference
are ended simultaneously
when the End key is
pressed.
Call menu
The following functions are only
available during a call:
; menu§ Open menu.
~
< < < < a a a a
Z Z
Carol
Hold A A A A menu
Micro-
phone on
Switch microphone on/off.
If switched off, the person
on the other end of the line
cannot hear you (muting).
Alternatively:
* Hold down.
However, numbers being
entered are audible when
Send DTMF tones is active.
Volume Adjust handset volume.
Conference (see left)
Duration/
charges
While the connection contin-
ues, the call duration and
(if set, p. 43) the charge de-
tails are displayed.
Send DT-
MF tones
(p. 73)
Call
transfer
The original call is joined to
the second one. For you,
both calls are now ended.
Main menu Access to the main menu.
Call status List all held and active calls
(e.g. participants in a confer-
ence).
~