Spirit XT385 - Manual (Page 8)

XT385 Treadmill 6
1. Install the four speed nuts ( 128) onto the tabs of the frame.
2. Take the Left and Right upright tubes (part numbers 5 & 4) and slip the upright covers (67 & 61
left, 66 & 62 right) onto the tubes (observe the cover orientation is correct). Connect the Middle
Console Cable ( 50) that exits from the bottom of the right upright tube with the lower Console
Cable ( 49). NOTE: Partially tighten all bolts in this step. This will allow for easier
console assembly.
3. Insert Right and Left Uprights ( 4) and (5) into the Frame Base (2) and attach with eight Button
Head Socket Bolts ( 130) using the Allen wrench/screwdriver (131). Attach two more Button
Head Socket Bolts ( 130) and two Flat Washers (147) on the inside surface of the upright tubes.
Be careful not to pinch the wire when installing the upright.
UPRIGHT TUBE ASSEMBLY
1
#130. 5/16” x 15mm
Button Head Socket
Bolt (10 pcs)
#147. 5/16” x 18 x 1.5T
Flat Washer
(2 pcs)
HARDWARE
#128. M5 Speed Nut
Clip (4 pcs)