Samsung ML-1200 - Manual (Page 53)

A PPENDIX A.5 A PPENDIX A.4
Paper Specifications Paper Specifications
For best results, use conventional 75 g/m 2 (20 lb) paper. Insure the paper is of good quality,
and free of cuts, nicks, tears, spots, loose particles, dust, wrinkles, voids, and curled or bent
edges.
If you are unsure of what type of paper you are loading (such as bond or recycled), check the
label on the package.
The following problems may cause print quality deviations, jamming, or even damage to the
printer.
Symptom
Poor print quality or
toner adhesion,
problems with feeding
Dropout, jamming,
curl
Increased gray
background shading
/printer wear
Excessive curl
problems with feeding
Jamming, damage to
printer
Problems with feeding
Problem with Paper
Too moist, too rough, too
smooth, or embossed;
faulty paper lot
Stored improperly
Too heavy
Too moist, wrong grain
direction or short-grain
construction
Cutouts or perforations
Ragged edges
Solution
Try another kind of paper,
between 100 ~ 250 Sheffield,
4 ~ 5 % moisture content.
Store paper flat in its moisture-
proof wrapping.
Use lighter paper, open the rear
output tray.
• Open the rear output tray.
• Use long-grain paper.
Do not use paper with cutouts or
perforations.
Use good quality paper
Notes:
• Do not use letterhead paper printed with low-temperature inks, such as those used in some
types of thermography.
• Do not use raised or embossed letterhead.
• The printer uses heat and pressure to fuse toner to the paper. Insure that any colored paper
or preprinted forms use inks that are compatible with this fusing temperature (200 °C or 392
°F for 0.1 second).
Category
Acid Content
Specifications
5.5 ~ 8.0 pH
Caliper .094 ~ .18 mm (3.0 ~ 7.0 mils)
Curl in Ream
Cut Edge Conditions
Fusing Compatibility
Grain
Flat within 5 mm (.02 in.)
Cut with sharp blades with no visible fray.
Moisture Content 4 % ~ 6 % by weight
Smoothness 100 ~ 250 Sheffield
Must not scorch, melt, offset, or release hazardous
emissions when heated to 200 °C (392 °F) for .1
second.
Long Grain
Paper Specifications
Output Tray
Face-down output tray
Capacity
100 sheets of 20 lb bond (75 g/m 2 ) paper
Face-up output slot 1 sheet of 20 lb bond (75 g/m 2 ) paper
Guidelines for Using Paper
Paper Output Capacity