Sony MZ-NH700 - Manual (Page 58)

58
• Settings for up to 64 discs can be stored. Any
settings stored afterwards will replace the
settings with the lowest frequency of use
among the 64. The numbers of discs that can
be stored depend on the numbers of tracks
recorded on the discs. More tracks recorded
per disc means fewer discs can be stored.
• If you try to erase the disc information of a
disc that have never been stored, “NO DISC
MEMORY” appears in the display for a few
seconds.
Starting the playback
quickly (Quick Mode)
The recorder is factory set to quickly start
playback after the playback button is
pressed.
You can check the setting as follows.
1
Enter the menu and select “Option” -
“QuickMode”.
2
Turn the jog dial until “Quick On”
appears in the display, and then press
NENT to enter the selection.
If you will not use the recorder
for a long time
Select “Quick Off” in step 2.
You can minimize battery drain while the
recorder is not being used.
When the quick mode is set to “Quick On”, the
power remains on within the recorder even
when nothing appears in the display. When the
battery becomes completely drained, the
internal power supply of the recorder turns off
automatically.
Selecting the disc
mode (Disc Mode)
When you insert a 60/74/80-minute
standard disc (blank) into the recorder,
you can use this function to specify use of
the disc in Hi-MD mode or MD mode.
If you want to use the disc recorded on
this unit on another component that does
not support Hi-MD, record the disc with
“Disc Mode” in the menu set to “MD”.
1
Enter the menu and select “Option” -
“Disc Mode”.
2
Turn the jog dial until “Hi-MD”
(factory setting) or “MD” appears in
the display, and then press NENT to
enter the selection.
Notes
5-way control
key (NENT)
NAVI/
MENU
Jog dial
Note
5-way control
key (NENT)
NAVI/
MENU
Jog dial