Samsung HT-DS1000 EN - Manual (Page 59)

Setting the Test Tone
Use the Test Tone feature to check the speaker connections and to adjust the speaker levels.
L: Front Speaker (L) C: Center Speaker SW: Subwoofer
R: Front Speaker (R) LS: Rear Speaker (L) RS: Rear Speaker (R)
Press RETURN button to return to the previous level.
Press MENU button to exit the setup screen.
58
SETUP
2 1 In Stop mode,
press MENU
button.
Press Cursor
button to move to
‘Audio’ and then
press ENTER button.
3
Press Cursor button
to move to ‘TEST
TONE’ and then press
ENTER button.
• The test tone will be sent to L ➝ C ➝
R ➝ RS ➝ LS ➝ SW in that order.
If the ENTER button is pressed again
at this time, the test tone will stop.
To end the test tone,
press TEST TONE button again.
Press TEST TONE button.
• Test tone will be produced as follows:
When playing a DVD or CD, this will work
only in Stop mode.
• Use this function to check that each speaker is
correctly connected and that there is no problem.
Alternate method: press the TEST TONE button on the remote control.
Multi-Channel Pro Logic Mode
Start
45P~82P(DS1000)-sea 9/15/04 2:44 PM Page 55