Simplicity SMI I924E - Manual (Page 31)

31
Adjustments/Service
Figure 36. Frame and Axle Housing Splitting
A. Upper Capscrews
B. Lower Capscrews
C. Auger Housing
D. Frame
C
Service
9. Remove hair pin (A, Figure 33) and slide rod (B)
backward about 3 inches (until shaft separates
from the worm drive).
B
A
Figure 33. Rotator Shaft Removal
A. Pin, Hair
B. Shaft
11. Lift the chute and rotator (A, Figure 35) off of the
auger housing.
Figure 35. Chute and Rotator Removal
A. Chute and Rotator
10. Remove two 5/16-18 KEPS hex nuts (A, Figure
34), and two 5/16-18 x 1-1/2 carriage bolts (B)
securing the offset tube (C) to the tube support
bracket (D).
Figure 34. Offset Tube (Lower) Removal
A. Nuts, KEPS, hex, 5/16-18
B. Bolts, Carriage, 5/16 x 1-1/2
C. Tube, Offset
D. Bracket, tube support
D
B
A
12. Remove the upper four capscrews (A, Figure 36)
that hold together the auger housing (C) and the
frame (D). Loosen the lower two capscrews (B).
The auger housing (C) and the frame (D) can now
be split apart for removal of the belt.
13. Remove the old auger drive belt (D, Figure 31)
from the impeller pulley. Replace the auger drive
belt with an original factory replacement belt
available from an authorized service center.
14. Install the new auger drive belt (D) onto the
impeller pulley.
A
C
A
D
B
Not
for
Reproduction