beautypg.com

Not for reproduction, Operation warning, Warning – Simplicity SMI I924E User Manual

Page 16: Caution

background image

16

Operation

Operation

WARNING

Rapid retraction of the starter cord (kickback)
will pull your hand and arm toward the engine
faster than you can let go. Broken bones,
fractures, bruises or sprains could result.
When starting engine, pull the starter cord
slowly until resistance is felt and then pull
rapidly to avoid kickback.

WARNING

If the extension cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person to avoid to
avoid a hazard.

STARTING THE ENGINE

1. Check the oil level. See the Engine Manual

How

to Check/Add Oil section

2. Make sure equipment drive controls are

disengaged.

3. Push the stop switch to the on position (A, Figure

3).

A

Figure 3. On/Stop Switch
A. On/Stop Switch Selector

4. Insert the engine key (A, Figure 4) into the engine

key slot and push fully in to the RUN position.

5. Turn the choke knob (B) fully clockwise if engine is

cold.

Note: Do not use the choke to start a warm engine.

6. Push the primer button (C) two times.

Note: Do not use the primer to start a warm engine.

Figure 4. Safety Key, Choke, and Primer Button
A. Safety Key
B. Choke Control Knob
C. Primer Button

C

A

B

7. Rewind Start: Firmly hold the starter cord handle

(A, Figure 5). Pull the starter cord handle slowly
until resistance is felt, then pull rapidly.

Note: If the engine does not start after three attempts,
see the Engine Manual Troubleshooting section.

8. Electric Start: First connect the extension cord to

the power cord receptacle and then into a wall
receptacle. If additional extension cord is
required, make sure it is 3-wire.

9. Electric Start: Depress the push button (A, Figure

6). After you start the engine, first disconnect the
extension cord from the wall receptacle and then
from the power cord receptacle (B).

CAUTION

To extend the life of the starter, use short
starting cycles (five seconds maximum.) Wait
one minute between starting cycles.

A

B

Figure 6. Electric Start
A. Starter Push Button
B. Power Cord Receptacle

Note: If the engine does not start after three attempts,
see the Engine Manual Troubleshooting section.

Figure 5. Rewind Start
A. Starter Cord Handle

A

Not

for

Reproduction

This manual is related to the following products: