Troubleshooting – Sony UP-DR80MD User Manual
Page 22
22
Troubleshooting
Mis
c
e
lla
neou
s
Troubleshooting
If a problem appears, check the following troubleshooting
guide first and perform whatever action is necessary to
solve the problem. If the problem persists, turn off the
printer and consult with your Sony dealer.
Symptom
Possible causes and remedies
The printer does not
print even though
images are being sent
from the computer.
• The printer is in the standby state (the
1 ON/STANDBY indicator is not lit).
t Press the 1 ON/STANDBY switch.
• The printer is not connected properly.
t Check the connections (page 10).
The printer does not
print.
• An indicator on the printer is
displaying an error status.
tRefer to “Explanation of Indicators”
on page 23 and take the appropriate
action.
The paper roll cannot
be loaded in the
media tray.
• The paper roll is being loaded with the
colors of the paper holders and the
colors on the media tray incorrectly
matched.
t Load the paper roll so that the
colors of the paper holders and the
colors on the media tray match
(page 15).
The paper does not
feed.
• The paper roll is loaded with the colors
of the paper holders and the colors of
the labels affixed to the paper roll
incorrectly matched.
t Load the paper roll so that the
colors of the paper holders and
colors of the labels affixed to the
paper roll match (page 14).
• The paper roll is loaded with the left
and right reversed (when the paper roll
has been reloaded).
t Load the paper roll in the proper
direction (page 15).
• The paper holder selector does not
match the size of the paper roll.
t Set the selector properly (page 13).
• The label affixed to the paper roll has
not been peeled off.
t Peel the label off properly
• The paper roll is wound to loosely.
t Rewind the paper roll and then load
• The leading edge of the paper roll is
folded.
t Cut off the folded part so that the
paper becomes straight (page 24).
The print area is
printed offset.
• The paper holder selector does not
match the size of the paper roll.
tSet the selector properly (page 13).
There are marks and
stripes on the print
side.
• The thermal head is dirty.
t Perform the cleaning operation
The media tray
cannot be opened.
•
The power may have been turned off
during the printing operation.
tPress the 1 ON/STANDBY switch
to turn on the power of the printer
and initialize the printer.
•
The printer may not have been able to
recover from an error.
tPress the 1 ON/STANDBY switch
to enter the standby state and then
press the 1 ON/STANDBY switch
again to turn on the power. If the
media tray still cannot be opened,
press the 1 ON/STANDBY switch
to enter the standby state and then
disconnect the power cord and
contact your dealer.
The fan turns when
the printer is in the
ready state.
•
The printer is performing temperature
control. This is not a malfunction.
Symptom
Possible causes and remedies