Sony UP-DR80MD - Manual (Page 20)

20
Ink Ribbon and Paper
Mis
c
e
lla
neou
s
4
Load the cleaning ribbon.
For details on how to load the cleaning ribbon, see
steps 2 and 3 of “Loading the Ink Ribbon and Paper”
on page 13.
Note
If there is any slack in the cleaning ribbon after it is
placed in the tray, take up the slack by turning the
spool in the direction indicated by the arrow in the
following figure.
5
Insert the media tray into the printer.
When the printer finishes initializing, the
CLEANING indicator flashes and cleaning starts
automatically.
When cleaning is completed, the CLEANING
indicator turns off.
6
Make sure that the printer is not performing an
operation, and then pull out the media tray.
7
Remove the cleaning ribbon.
8
Load the ink ribbon.
9
Insert the media tray into the printer.
Notes
• Store the cleaning ribbon in a location without dust (such
as in a bag).
• Place the removed media tray on a stable surface when
loading and removing the cleaning ribbon.
• Dropping the media tray while paper is loaded may
result in an injury. When pulling out and inserting the
media tray, hold the handle part with one hand and
support the media tray from the bottom with the other
hand, while making sure both of your hands are securely
holding the media tray.
Ink Ribbon and Paper
Laminate Color Printing Pack UPC-R80MD
Contains two color ink ribbons and two rolls of paper (A4-
size width).
Laminate Color Printing Pack UPC-R81MD
Contains two color ink ribbons and two rolls of paper
(Letter size width).
Printable quantity
The number of printouts that can be made with a single set
of ink ribbon and paper is shown below.
Notes
• Do not change the ink ribbon and paper roll when they
are only partially used. Doing so can cause problems.
The number of printouts indicated above is not
quarantined.
• When the ink ribbon is used up, replace both the ink
ribbon and the paper roll.
IC board
Direction to
turn spool
Printing pack UPC-R80MD UPC-R81MD
Number of sheets 50 sheets 50 sheets
Print size A4 Letter