Sony PX35 User Manual
Page 42
GB
42
Troubleshooting
Sound
On-screen display does not
appear.
• Status in the MENU SETTING menu has been set to Off.
c Set Status in the MENU SETTING menu to On (see page 36).
Color balance is incorrect.
• Picture has not been adjusted properly.
c Adjust the picture (see page 31).
• Projector is set to wrong color system.
c Set Color System in the SET SETTING menu to match the color
system being input (see page 35).
The picture is too dark.
• Contrast or Brightness has not been adjusted properly.
c Adjust the Contrast or Brightness in the PICTURE SETTING
menu properly (see page 32).
• The lamp has burnt or dims.
c Replace the lamp with a new one (see page 38).
The picture is not clear.
• Picture is out of focus.
c Adjust the focus (see page 25).
• Condensation has occurred on the lens.
c Leave the projector for about two hours with the power on.
The image extends beyond
the screen.
• The APA key is pressed although there are black edges around the
image.
c Display the full image on the screen and press the APA key.
c Adjust Shift in the INPUT SETTING menu properly (see page
The picture flickers.
• Dot Phase in the INPUT SETTING menu has not been adjusted
properly.
c Adjust Dot Phase in the INPUT SETTING menu properly (see
Symptom
Cause and Remedy
No sound.
• Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made (see page
18).
• The audio connecting cable is incorrect.
c Use a no-resistance stereo audio cable (see page 19).
• The sound is not adjusted properly.
c Adjust the sound (see page 25).
• The audio is muted.
c Press the AUDIO MUTING key to cancel muting.
When sound is input
through AUDIO connector,
sound comes through one
channel only.
• Monaural sound is being input through the AUDIO connector.
c Input stereo sound.
Symptom
Cause and Remedy