Smart Technologies X-Port 20 Switch XP20-2000i - Manual (Page 6)

3. Remove the sticker covering the lower DB9 opening. Place the supplied label over this
opening.
DB9 Connector
Opening
(Sticker Removed)
Supplied Label 2000i (Back Leg Removed
for Clarity)
Compu
ter 2
4. While propping up the Electronics tray with one hand (so it doesn’t fall suddenly), remove the
two button head screws on either side, using the 5/32" hex key (provided in the accessory kit
for the 2000i). Put the screws in a safe place as you’ll need them to secure the Electronics
tray at the end of this installation.
Button Head Screw
Button Head Screw
Location of Button Head Screws
X-Port 20 Switch Installation Guide for the 2000i 99-00486-00 Rev B0 2